A250 LIQUIFLEX Fascia Trim
Edge detail to cover insulation.
Usually used with a warm roof specification.
Deep fascia to allow gutter penetration.
The A type trim is a drip trim, fitted to the lowest edge of the roof.
It is usually positioned where the rainwater flows into the gutter.
Two support battens should be fixed to the perimeter of the roof to provide space for the gutter to fit behind the trim.
The outer batten should be attached 10mm lower than the inner batten to allow the trim to sit flush with the roof.
Apply trim adhesive to the batten in 30mm beads at 300mm centres.
Then, rub the trim into place and nail to the decking.
Do not nail through the front of the trim.
If the pitch of the roof is only minimal, rainwater is likely to hold behind the trim.
A planning machine can be used to take 2mm off the deck to allow the trim to lay flush with the board.
Girth – 250mm
Depth – 140mm